Level the EFX.

Before exercising, make sure the EFX does not wobble from side to side or front to back. Ask a capable person for help to make adjustments.

Important: If the unit is placed on a slightly uneven surface, adjusting the rear pads can help, but will not compensate for extremely uneven surfaces.

1.To remove any side-to-side movement, rotate the rear pads.

2.To counteract any front-to-back rocking motion, ask your assistant to

grasp the upper handrails and raise the front of the unit off the floor. Use a crescent or combination wrench to loosen the nut on the height adjuster.

3.Turn the height adjuster to eliminate the rocking motion.

Once you have the proper height adjustment, use the wrench to turn the nut and tighten it securely against the base tube.

Important: If, sfter performing the steps above, the unit still rocks slightly from front to back, you may need to remove the nut on the height adjuster.

4. Have your assistant carefully lower the unit to the floor.

Precor Incorporated

20031 142nd Avenue NE

P.O. Box 7202

Woodinville, WA USA 98072-4002

Connect the power cord.

CAUTION: Use the supplied power cord. Do not remove or otherwise bypass the 3-prong plug with an adapter in order to use a non-grounded outlet. Do not plug the EFX into a power transformer in an attempt to adjust the voltage requirements. Failure to follow these instructions might damage the unit and void the Precor Limited Warranty.

1.Insert the power plug connector into its receptacle at the rear of the unit.

2. Plug the other end into a grounded outlet. Be sure to use the appropriate voltage. Refer to Grounding Instructions in the owner’s manual.

Turn the unit ON.

Use the ON/OFF (I/O) power switch to turn the unit ON. Check that the Precor banner appears on the display. If the display remains blank, recycle the power, and then check the cable connections.

©2005 Precor Incorporated

www.precor.com

EFX5.33 AG 48170-403, en

03 October 2005

Page 68
Image 68
Precor 5.33, 5.23 manual Have your assistant carefully lower the unit to the floor