Owner’s Manual: Programs 36
During the program, the TIME display relates to the amount
of time remaining in the recorded columns. Total elapsed
time appears when you record new columns.
Note: The length of the custom program and number of
speed and incline settings are limited to the available
memory in the treadmill. The program will not end if the
available memory is exhausted, but the display notifies you,
and
further changes to speed or incline are not saved.
Approximately six hours of recording time is available for
the two user IDs.
Clearing the Settings on a Custom Program
Perform the following steps to clear (delete) any speed or
incline settings stored in a custom program.
1. At the Precor banner, press USER 1 or USER 2, and then
press ENTER.
2. Use any arrow key to specify the custom program (CST1
or CST2) that you wish to clear.
Important: Clearing the speed and incline settings from a
custom program permanently deletes them from memory.
3. While the program name is blinking, press and hold the
SELECT key associated with the user ID specified earlier
for ten seconds. After the message CLEARED appears
on the display, you can release the key. Speed and incline
information are rest to zero.
Note: During the 10-second delay, you can release the
SELECT key and no change will occur to the custom
program settings.