Selecting a U.S. Standard or Metric Display
The treadmill can display measurements in either U.S. Standard (U.S. STD) or METRIC. The default factory setting is set to display U.S. STD. To change this setting, perform the following steps:
1.At the Precor banner, press the following keys in sequence and without pause:
RESET, QUICKSTART, ENTER, SELECT [USER 2], INCLINE ▲
As shown in Diagram 9, numbers are associated with the keypad. The numbers 5, 6, 7, 1 appear on the display as you press the associated key.
1 |
|
|
|
|
| 9 |
2 | 3 | 4 | 5 | 6 | 7 | 8 |
|
|
|
|
|
Diagram 9: Keypad programming numbers
2.SELECT UNITS appears, followed by the current unit of measure (U.S. STD or METRIC). Use an arrow key to switch between the options.
3.Press ENTER to accept the displayed setting.
The change will be retained in memory even if the treadmill is turned OFF and unplugged.
4.To continue programming the treadmill to change password protection, refer to Selecting Password Protection.
5.If you want to end programming, press RESET.
Owner’s Manual: Advanced Programming and Troubleshooting | 38 |
