Q-Logic 59060-02 B manual AdminState

A

3 – Event Messages Alarm Events

(A1005.0022) (Blade in slot slot_number must be reset after leaving Diagnostics

AdminState)

Meaning:	After changing the switch administrative state from Diagnostics to
	any other state, the blade must be reset to complete the state
	change.
Action:	Reset the blade.

(A1005.0024) (Switch must be reset after leaving the Diagnostics Admin State)

Meaning:	After changing the switch administrative state from Diagnostics to
	any other state, the switch must be reset to complete the state
	change.
Action:	Reset the switch.

(A1005.0034) (System resource error - contact technical support)

Meaning:	There is a system resources problem on the switch.
Action:	Contact technical support.

(A1005.0035) (System resource error - contact technical support)

Meaning:	There is an internal problem on the switch.
Action:	Contact technical support.

(A1005.0036) (Hotswap procedure failed before last reset - must hardreset switch)

Meaning:	The blade hotswap procedure failed and the switch was reset
	without a power-on self test.
Meaning:	Reset the switch with a hard reset.

(A1005.0037) (Hotswap procedure never completed - the blade will not be functional until the switch is hardreset)

Meaning:	The blade hot-swap procedure was not completed.
Action:	Reset the switch with a hard reset.

(A1005.0038) (Switch incompatibility error - contact technical support)

Meaning:	Switch incompatibility error.
Action:	Contact technical support.

(A1005.0039) (Fabric Login (FLOGI) from address FC_address failed)

Meaning:	The payload of the FLOGI was not valid.
Action:	Check device connection or replace the device. If the problem
	persists, contact your authorized maintenance provider.

59060-02 B 3-19