Q-Logic 59060-02 B manual A1007.0025 Security feature not supported

A

3 – Event Messages Alarm Events

(A1007.0020) (MAX Retry count reached on CHAP Authentication Protocol Reset, failing Authentication)

Meaning:	A RADIUS server has rejected a RADIUS authentication request.
Action:	Check the configuration on both the switch and on the RADIUS
	Server for incompatibilities.
(A1007.0021) (No response to RADIUS access request for device on port port)
Meaning:	A configured RADIUS server did not respond to an authentication
	request within the timeout period.
Action:	Check RADIUS server configuration and the RADIUS server.

(A1007.0022) (Invalid response authenticator from RADIUS server IP_address:port, check shared secret)

Meaning:	RADIUS server configuration issue.
Action:	Check the shared secret. The shared secret must be configured on
	both the RADIUS server and the switch.

(A1007.0023) (Invalid response authenticator from RADIUS server IP_address:port, check

shared secret
Meaning:	There is a RADIUS configuration problem.
Action:	Confirm that the shared secret configured on the switch is identical
	to the shared secret configured on the RADIUS server.

(A1007.0024) (Invalid access accept from RADIUS server IP_address:port, bad or missing

Service-Type)
Meaning:	A service-type RADIUS attribute was not found within a RADIUS
	packet.
Action:	This is a RADIUS Server configuration issue. Consult your
	RADIUS server documentation.
(A1007.0025) (Security feature not supported.)
Meaning:	The switch is coming out of Non-Disruptive Code Load and
	Activation (NDCLA) and had an active security prior to the NDCLA,
	but the security feature is no longer supported.
Action:	A license key may be required for the security feature.

(A1007.0026) (Unable to validate Chap Response from device_WWN, possible Chap secret misconfiguration or security breach attempt.)

Meaning:	A CHAP authentication attempt failed due to failure while
	comparing secrets.
Action:	Check security configuration.

59060-02 B 3-25