RAD Data comm RIC-155 Managing RIC-155 via Data Port

RIC-155 Installation and Operation Manual Appendix B Traffic Separation
Configuring for a Typical Application B-7
The units are configured as follows:
• Local RIC-155:
 Forwarding – Filter Tagged
 Port Management Access – MNG Only
 Host Tagging – Untagged
 Management and data ports – Tag stripping is enabled
 uplink port – Stack.
• Remote RIC-155:
 Forwarding – Filter Tagged
 Port Management Access – None
 Host Tagging – Untagged
 Management and data ports – Tag stripping is enabled
 uplink port – Stack.
When the forwarding mode is set to Filter Tagged or port access mode is set to
MNG Only, the following parameters are enabled automatically:
• Tag stripping at the management and data ports
• Stacking at the uplink port.
MNG
11
11
Local RIC-155 Remote RIC-155
2
22
2
Host Host
Uplink Uplink
Data
Management
Station
LAN LAN
Data
Figure B-9. Managing RIC-155 via MNG Port
Managing RIC-155 via Data Port
Figure B-10 shows two RIC-155 units managed via data port. In this application the
management and data frames are tagged by an external switch and sent to the
data port. The Data port is configured to leave the incoming frames unchanged
(tag stripping is disabled). At the egress from the data port, the management frames
are forwarded to the host and uplink ports, and the data frames are sent to the
uplink port only. The host port adds VID 1 to the management frames to ensure
that they reach the management station when they are sent back. At the egress
from the uplink port, no tags are added to the frames, because they arrive tagged.
When the frames enter the remote uplink port their tags are checked against the
remote VTU table and forwarded according to their tags: 1 to the host port and 2
to the data port. The host port strips the VLAN tag of the management frames and
forwards them to the CPU.
Note