Beyond the Basics
bank once, while in locked out review mode, hold down L/O for 3 seconds. All locked out IDs in a bank are restored.
setting the delay mode for trunking mode
A default delay of 2 seconds is automatically set for each talk group for ID scan mode and ID search mode. To set the delay feature on or off, press DELAY while trunking. DLY will appear or disappear, depending on your setting.
trunking frequency confirmation
You can check the frequency while a talk group ID is active.
Press the d key, and the active frequency on which the talk group is transmitting will flash on the display. Or press and hold the d key for 2 seconds. The ID and the frequency alternately appear on the display. To cancel this mode, press the d key again.
Note
This feature is applied to ID scan mode and ID search mode.
setting priority in trunking mode
You can set priority in your scan lists, just as you do in your conventional ones. The default setting for the priority ID is the first location in each scan list. You can set the priority by pressing and holding PRI for 2 seconds in ID scan hold mode. After you’ve set up your scan list, press PRI to activate it. It is very similar to conventional priority although there is no “interrupt” during the transmissions. Priorities are checked in between transmissions.
With priority on, you can hold on an ID in your scan list, such as scan list 3, memory location 7, and the scanner will check all the priorities in all the active scan lists in between any transmissions on the ID on which you’re holding. The lowest numbered priority will be checked first. For example, the
56
