Extron electronic ISM 824 manual Setting the RBG delay, Audio Settings

Setting the RBG delay

To set the RGB delay, do the following:

1. Click in an output RGB Delay field where delay (in 0.1 seconds intervals) is to be changed. Up and down scroll arrows appear (see figure 5-26).

Figure 5-26 — Enter a value, or scroll the arrows to the desired setting

2. Either directly enter a value for the RGB delay (e.g. 1.7), or scroll the arrows to

the desired setting. Minimum is zero (0), maximum is five (5.0) seconds.

Audio Settings page

Selecting the third tab opens the Audio Settings page and shows the current audio settings (see figure 5-27). Use this page to configure different input gain and attenuation levels (from +24 to -18 dB) for each input, and different volume levels (from 0 to -64 dB, where value 0 = -64 dB, 64 = 0 dB ) for each output. In addition, all inputs and outputs can be set to the same level as those set for input 1. The minimum and maximum value are shown.

Figure 5-27 — Enter a value or scroll arrows to desired setting

ISM 824 Integration Scaling Multiswitcher • ISM 824 Multiswitcher Software 5-17