Extron electronic ISM 824 manual Output Cards, Create an input to output tie

Output Cards page

Selecting the fourth tab opens the Output Cards page, which allows the user to individually configure up to four output cards. Each installed configurable card has a radio button next to the name. Click on this button to choose the card to be configured.

NNon-configurable cards, such as wideband cards, show a grayed-out radio button.

Universal Scaler

Use this page to configure the Universal Scaler output card (for any input) for the following settings:

•create an input to output tie

•picture adjustments — image color, tint, brightness, contrast, detail, horizontal and vertical positioning, horizontal and vertical sizing, and zoom

•input settings — pixel phase, number of active and total pixels, number of active lines, and number of the horizontal and vertical start point

•aspect ratio — select a value (16:9 or 4:3)

•output configurations — resolution, output type, output rate, and sync polarity

•advanced configurations — test pattern selection, film mode, blue mode, RGB signal pass-through selection, auto image, and auto memory

•user presets (presets #1-3) — save and recall

•input presets (presets # 1 through 128) — save and recall

•Start Auto image

•Freeze (image)

Figure 5-30 — Current Universal Scaler output card settings

NEach input to any output card can have different picture adjustments settings. The image control default settings are 50% of the min/max (see figure 5-30). Some values may be auto detected (e.g. for H and V size), and values that are not available are shown as N/A.

ISM 824 Integration Scaling Multiswitcher • ISM 824 Multiswitcher Software 5-19