Extron electronic ISM 824 manual View Comm Settings menu, Input

View Comm Settings menu

The fourth menu level, View Comm Settings is reached by pressing the Menu button four times from the default display cycle, or if at a different menu, by pressing the button repeatedly times until this menu is shown on the LCD screen.

Default

Cycle

NOTE Changes can only be made while in the Edit mode.

To enter the edit settings mode, press and hold the Enter, Preset,View, and Esc buttons together for 2 seconds. The LCD screen changes from View Comm settings to Edit Comm Settings.

	Menu
		30 sec.			30 sec.
	Auto		Menu	Remote Port
	Image			9600	RS232
	Menu				In edit mode, rotate		encoder to select the baud rate.
	Input				Rotate	encoder to select the connection type (RS-232
					or RS 422) for the rear panel 9-pin D-sub control port
	Configuration
					Next
	Menu		30
			sec.	Config Port
	Output Card
				9600	RS232
	Configuration				In edit mode, rotate		encoder to select the baud rate.
30	Menu				Rotate	encoder to select the connection type (RS-232
	View Comm				only) for the front panel config. port
sec.		Next			Next
	Settings		30
			sec.	MAC Address
	Menu					NOTE This setting cannot be changed.
30				005A602395B
sec.	System Reset				Next
	Menu		30
			sec.	DHCP Mode
					Off
					Rotate either encoder to turn DHCP
					Mode On or Off

30

sec.

Next

IP Address 192.168.254.254

30

sec.

In edit mode, rotate encoder to select the field to edit. Rotate encoder to change the field value.

Next

Subnet Mask 255.255.255.000

30

sec.

In edit mode, rotate encoder to select the field to edit. Rotate encoder to change the field value.

Next

Gateway Address Next

000.000.000.000

In edit mode, rotate encoder to select the field to edit. Rotate encoder to change the field value.

Figure 3-50 — View/Edit Comm Settings menu

This menu allows the user to view the following device communication settings: Remote port, Config. port, Mac address (view only), DHCP mode, IP address, Subnet mask, and Gateway address.

NThese settings can only be changed when in the Edit Comm Settings menu. See “Editing the communications settings” section in this chapter for method.

To simply view the Comm settings, do the following:

1.	From the default cycle, press the Menu button four times to go to the View
	Comm Settings menu (see figure 3-50)
2.	Press the Next button to enter the first sub level, Remote Port (rear panel).
3.	To view the remaining settings, continue to press the Next button and
	navigate through each setting.

4. Press Next in the Gateway Address menu to return to the View Comm Settings.

NPress the Menu button to go directly to the next top level (System Reset) menu.

ISM 824 Integration Scaling Multiswitcher • Operation and Setup 3-41