Extron electronic ISM 824 Output card configuration menu, Universal Scaler configuration menu

NWhen the sub level is entered, the last selected input lights steady green. All other input buttons flash green.

3.	Select the desired input by pressing its button. That button lights green, and
	all other buttons flash green. The LCD screen indicates the input number
	selected.
4.	Rotate either encoder to select the signal format for that input.
5.	Either select another input and repeat step 4, or press the Next or Menu
	buttons to exit up to the top level menu. Alternatively wait 30 seconds for the
	device to time out to the default display.

Output card configuration menu

This third menu level is reached by pressing the Menu button three times, or a number of times until the Output Card Configuration menu is shown in on the LCD screen. This series of submenus is used to configure the optional Universal and Video Scaler output cards.

NUniversal Scaler and Video Scaler cards have a different set of submenus and are discussed separately.

Press the Next button to bring up the first submenu (Select Output). The last configurable output button selected lights green. If a different output type is to be configured, press the output button for that card, or rotate either front panel encoder to select the output.

Universal Scaler configuration menu

To configure the Universal Scaler card using the Output Card Configuration menus (see figure 3-44), follow the steps in each submenu shown below.

The Output Card Configuration submenus for the Universal Scaler card are; Select Output, Input Setup, Output Config., User Presets, and Advanced Config.

NWithin any submenu, press the Menu button to go directly to the top level (Output Card Configuration) menu.

If no front panel buttons or encoders are used for 30 seconds, the device times out and goes back to the default display cycle.

If a Universal Scaler card (ISM RGB) is installed, during power up a color bar test briefly appears on the display device.

ISM 824 Integration Scaling Multiswitcher • Operation and Setup 3-31