Extron electronic ISM 824 manual Video Scaler ISM VS, For the Video Scaler is shown below

Video Scaler — ISM VS

The page for the Video Scaler is shown below:

Figure 6-18 — Video Scaler output card configuration screen

On the top of this page, the input number that is currently tied to the card’s output tie is shown (see figure 6-18).

Also from this page adjustments to the following can be made;

•picture controls (color, tint, contrast, brightness, detail, horizontal and vertical position and size, and zoom)

•user and input presets can be saved and/or recalled

•output configuration parameters (resolution, refresh rate, sync format, and polarity) can be changed

•advanced configuration settings (top and bottom blanking settings, blue mode,

2:2 pull down, edge smoothing filter, enhancement mode, auto memory, and auto image) can be turned on or off.

To make picture adjustments do the following:

1. Within the Picture Controls section, select the setting that is to be changed, and click on either the left arrow (<) to decrease the value, or on the right arrow (>) to increase the value, one step at a time. After every click the page refreshes and shows the new value. The device is updated to the new setting.

NAlternatively, if the new setting value is known, enter it directly into the field, and press enter. The page refreshes, shows the new value, and the device is updated.

ISM 824 Integration Scaling Multiswitcher • HTML Operation 6-19