ISM 824 Multiswitcher Software, cont’d

Selecting blue mode, 2:2 Pull down, Edge smoothing filter, Auto image,or Enhancement mode

To select blue mode, 2:2 Pull down, Edge smoothing filter, auto image or enhancement mode from the advanced configuration settings, do the following:

1.

To select any of these settings, click the check box alongside the setting name.

NIf blue mode is selected (set to on), only the sync and blue video signal are passed to the display.

2:2 pull down is greyed out when not available for a selected input signal type

When the edge filter is selected (set to on), it reduces or eliminates aliasing, and the resulting jail bar effect.

When the enhancement mode is selected (set to on), automatic gain control of the video input signal is enabled.

Deselecting or re-selecting auto memory

Auto memory is enabled by default, and should only be disabled if input presets are to be used. See “Saving inputs presets”, below for details.

To deselect (or re-select) auto memory, do the following:

1. Click in the Auto memory box. When enabled, the green check mark is

shown.

Setting top and bottom blanking values

To set top and bottom blanking values in the advanced configuration settings, do the following:

1. To select any of these settings click in the blanking value field to be changed, the value field will open and show two scrolling arrows.

2. Either; using the arrows, scroll up or down to the desired setting, or directly type in the value. Press Enter. The output’s blanking area is set to that value.

NIf a value exceeding the minimum or maximum levels (see Min/Max column) is entered, the program defaults to the minimum or maximum level.

Saving or recalling user presets

To save or recall user presets, do the following:

1.

Click one of the user preset buttons (Preset # 1 through 3).

2.

Click Save to save the preset to that selected number, or click Recall to recall

 

the selected preset.

NSaving a preset, saves the users configuration to the selected preset number. Previous saves to that number are overwritten.

Saving input presets

NInput presets store all input settings to one of 128 memory locations, to be recalled via SIScommands. See chapter 4, SISProgramming and Controlfor command details

To save an input preset, do the following:

1.

Click the drop down arrow in the presets field. A list of presets (1 through

 

128) appears.

2.

Scroll to and click on the desired preset number. The preset field shows the

 

preset number selected.

3.

Click Save to save the preset to that selected number.

5-24 ISM 824 Integration Scaling Multiswitcher • ISM 824 Multiswitcher Software

Page 126
Image 126
Extron electronic ISM 824 manual Deselecting or re-selecting auto memory, Setting top and bottom blanking values