Extron electronic manual ISM 824 Integration, Default

	NOTE	When entering the first submenu, Select Output, the last selected scaler card output button and
Default		its associated input button lights green, and the LCD indicates the selected output. If another
Cycle		output is desired, press that output button, or rotate either front panel encoder to select it.

Menu 30

30 sec.

		sec.
	Auto
	Image
30		Menu
sec.	Input

Menu

30

sec.

Select Output #8 Video Scaler

Next

#8 Video Scaler Output Config

Menu

30 sec.

#8 Video Scaler User Presets

Menu

Menu	30 sec.
#8 Video Scaler
Advanced Config

Configuration

Next

30

Next

ISM 824 Integration Figure 3-48 — Output

30		Menu
sec.	Output Card
	Configuration		Next
30		Menu
sec.	View Comm
	Settings
30		Menu
sec.	System Reset
	Menu

	Resolution
30	1024x768	60
sec.	Rotate	encoder to
	adjust pixel value
	Rotate	encoder to
	adjust refresh rate
	Next
	Output Type
30	RGBHV
sec.
	Rotate either encoder
	to select output type
	(RGBHV, RGBS,
	RGsB, YUV Bi-Level)

sec. Save Preset <NA> 1 2 3

Rotate either encoder to select a preset to save current settings

30Next

sec.

Erase Preset	Next
<NA> 1 2 3

Rotate either encoder to select a preset

to erase

		Auto Image
		Input #2 On
		Rotate	encoder to
		select input
		Rotate	encoder to
		turn On or Off
		Next
	Top Blanking		Bot
	000		000
		Rotate either encoder
		to adjust top and
30		bottom blanking area
		Next
sec.
		Filter

Scaling Multiswitcher	configuration menu
• Operation and Setup	for Video Scaler card
3-37

30	Next
sec.		Next
	Sync Polarity
	H - V -

Rotate either encoder to change sync polarity

NOTE Within any sub menu, press the Menu button to go directly to the top level (Output Card Configuration) menu.

Video Scaler Output Card Configuration submenus

Off <On>

Rotate either encoder to turn encoder filter On or Off

30Next

sec.

Blue Mode

<Off> On

Rotate either encoder to turn Blue Mode On or Off

30Next

sec.

Auto Memories

Off <On>

Rotate either encoder to turn auto memories On or Off

30Next

sec.

2:2 Pulldown

Off <On>

Rotate either encoder to turn 2:2 Pulldown On or Off

30Next

sec.

Enhanced Mode		Next
<Off>	On

Video Scaler configuration menu To configure the Video Scaler card using the Output Card Configuration menus (see figure 3-48), follow the steps in each submenu shown below. The Output Card Configuration submenus for the Video Scaler card are: Select Output, Output Config., User Presets, and Advanced Config. N Within any submenu, press the Menu button to go directly to the top level (Output Card Configuration) menu. N If no front panel buttons or encoders are used for 30 seconds, the device times out and goes back to the default display cycle.

Rotate either encoder to turn enhanced mode On or Off