Extron electronic ISM 824 manual Creating a tie, Removing a tie

I/O control page

Selecting the first tab, opens the I/O Control page. Upon opening, this page shows the current configuration for input to output ties, video/audio tie modes (follow all or breakaway), and output mute status. Use this page to create or remove ties, mute or unmute output signals, and save, recall or delete presets.

Creating a tie

To create an input to output tie do the following

1. Select the Video/audio mode; “Follow all” or “Breakaway” (see figure 5-19).

￿

b

￿

Figure 5-19 — Create ties on the I/O Control page

N“Follow all” ties the input video and audio signal to the same output, whereas “Breakaway” allows the video and audio signals to be tied to different outputs.

2.	Drag and drop the desired input button over to the desired output button and
	release. A broken line appears (green for video, red for audio), connecting the
	input and output button (see input 3 and output 5 in figure 5-19). Repeat as
	desired for all ties that need creating.
3.	Click Take. The ties are created and any broken lines become solid.

Removing a tie

To remove an input to output tie do the following:

1.	Select the Video/audio mode; “Follow all” or “Breakaway”.
2.	Drag either the desired output or input button over to the waste bin icon and
	release. A broken line appears (green for video, red for audio), connecting the
	input and output buttons.

NSelect “Follow all” to remove both video and audio ties at the same time, and drag the button from either the video or the audio section.

NSelect “Breakaway” if only the video tie, or only the audio tie is to be removed. Drag the button from the relevant section.

3. Click Take. The ties are removed and any broken lines disappear.

ISM 824 Integration Scaling Multiswitcher • ISM 824 Multiswitcher Software 5-13