Beyond the Basics

scanning highway patrol, local police, and private frequencies

If the scanner is set to any mode other than the highway patrol, local police, or private mode, press PVT and then press STATE to display only HIGHWAY. Once HIGHWAY appears on the display, use the table below.

Press these buttons

Action

 

 

FUNC + HWY/POL (1x)

Scan highway patrol and local police

 

 

FUNC + HWY/POL (2x)

Scan only local police

FUNC + HWY/POL (3x)

Scan only highway patrol

To scan highway patrol, local police and private frequencies, press PVT. Once both HIGHWAY and PRIVATE appear on the display, use the table below.

Press these buttons

Action

FUNC + HWY/POL (1x) Scan highway patrol, local police and private frequencies

FUNC + HWY/POL (2x) Scan local police and private frequencies

FUNC + HWY/POL (3x) Scan only private frequencies

FUNC + HWY/POL (4x) Scan highway patrol and private frequencies

If your scanner is in a mode other than highway patrol, local police, or private, press PVT. The previously selected bank or banks appear. When the scanner receives a signal, scanning stops and the state code and frequency appear. When the transmission ends, the scanner holds for 2 seconds on that frequency for a response. For more information about the delay feature, see “Delay”. If there is no response, scanning resumes.

34

Page 34
Image 34
Radio Shack 20-426 manual Press these buttons Action