Indicators, 10Base-T port LEDs, Power LED | RadioLAN DockLINK

Appendix A: Indicators, Switches, and Connectors

Indicators

10Base-T port LEDs

There are two built-in LEDs, located on the 10Base-T connector, which provide Link and Port Activity information.

The Link LED (green) is active when the port is connected to another powered 10BaseT port whose signaling meets the requirements for an IEEE 802.3i 10BaseT device. For example, valid Link test pulses are detected on the receive pair.

The Activity LED (green) is active when receive activity is detected or during a packet transmission.

Power LED

The Power LED (green) is active when power is provided to the unit.

Fault LED

The Fault LED (amber) is active when a fault is detected during power up diagnostics.

890-010 12/04/98

Page 91

© 1998 RadioLAN.

Image 99

RadioLAN DockLINK manual Indicators, 10Base-T port LEDs, Power LED, Fault LED

Contents

Wireless Local Area Network DockLINK User Guide FCC Remarks Fccid Mcipuniit Disclaimer Manual Conventions Trademark Disclosures Table of Contents Recording Important System Information Troubleshooting Glossary DockLINK and Radio Unit Introduction 890-010 12/04/98 Designed for Simplicity Adding Security to the Wireless Network Station Local Management System RequirementsBrowser Requirements Quick Installation Steps Quick Installation Steps To Test the Antenna Placement Designing Your System Testing Data Range Testing the Data Range Network Requirements Installing the DockLINK Locating the Radio Unit Do thisDo not do this Connecting the DockLINK Connecting the DockLINK Setting the MDI/MDI-X Switch Connect the DockLINK Initial IP Address Setup 890-010 12/04/98 Optional Configuration Disk DockLINK Manager Using the DockLINK Manager Logging Onto the DockLINK Manager Accessing the DockLINK with the Browser Enter Password Product IDEnter User Name Main Menu DockLINK Manager Layout Main Node Discovery Network Information Page Station List Tab Discovering Wireless Nodes Within the DockLINK’s Data Range Type Station ListName Address Link Quality Ratings Link Node Discovery Network Information Page Connectivity Tab Connectivity Setting Up Security Features User Password and Retype Password FieldsUser Logon Name Fields Reload IP Parameters Default Gateway IP Address IP AddressSubnet Mask Dhcp Operation Modes Disabled Radio Button Dhcp Server IP Address Acquire system IP Only Radio ButtonDownload System Software Only Radio Button Download System Software and Save It Radio Button Dock Mode Setting the DockLINK’s Mode of Operation Securing the DockLINK with Data Encryption DockLINK data packetsEncryption Key and Retype Encryption Key 10BaseT Port Parameters Setting up10BaseT Port Parameters MAC Address Filter Edit ButtonBlock IP Packets Block NetBIOS Packets Block IPX PacketsBlock NetBEUI Packets Port Name Radio Port Parameters Edit Subnet ID Block IP Packets Block NetBEUI Packets Console Parameters Setting the Baud Rate for the Local Port MAC Address Table Managing Packet Flow through the DockLINK MAC Address Mask BytesSource/Dest Adding MAC Filters Accept/Reject Deleting MAC Filters Modifying MAC Filters Interrogating DockLINK for Performance Information Total Packets Transmitted Checking 10BaseT Port Statistics Total Packets Received Radio Port Statistics Checking Radio Port Statistics Packet Transmission Average Transmit Rate Packets/SecTotal Retransmission Average Receive Rate Packets/Sec Packet Reception Upgrading System Software File to Upload System Software File Name Upgrading from a Tftp ServerAddress field. Do not use this selection with DockLINK Set Tftp Server IP Address Save All Changes and Reset Radio Button Saving or Rejecting Configuration Setting Changes Reset Configuration to Factory Default Radio Button Reload Last Saved Configuration Radio Button Reset Resetting the DockLINK Setting the Frames to Send Testing DockLINK Connectivity to the Wireless Network Frames Acked Setting the Frame SizeSetting the Address Frames Sent Stop Button Success %Avg Retrans Start Button System Information Recording Important System Information Subnet ID Boot Software Version System Log Viewing the System Log Managing the DockLINK Locally Connecting the VT-100 Terminal to the DockLINK Serial Port Adapter Cable Pin-outs Signal Description DB-9F RJ11 DockLINK Local Management Prompt For more information, see Station Name Configuring the DockLINK for use in the Dock Mode Serial Number Logging onto the DockLINK Configuration Screen Enter User Name Node Discovery Using the Main Menu System Statistics Menus System Configuration Menu Working with the System Configuration Menu Port Parameters Menus Snmp Parameters Access Security User Logon Name Configuration Manager Menu ItemsUser Password Menu Name Menu Item Refer to Address Default Gateway IPMenu Name Menu Item Refer to IP Address Subnet Mask Menu Name Menu Item Refer to Dhcp Operation Mode Dock ModeData Encryption Mode Menu Enable EncryptionEncryption Key 10BaseT Port Parameters Edit MAC Filters Block NetBIOS PacketsSubnet ID Block MAC Packets Accept or Reject Packet When SatisfiedList all Filters Configured Address Filtering Menu Name Menu Item Refer to Radio Port Statistics Download Mode Perform Download Save All ConfigurationMenu Name Menu Item Refer to Tftp Server IP Address System Software Name Ping Frame Size ConfigurationsReset All Configuration Ping Frame Count Average Retransmission Menu Name Menu Item Refer to Perform PingTotal Packets Transmitted System Log Menu Name Menu Item Refer to System Information Troubleshooting IndicatorsProblem No traffic passed Problem Radio Range seems less than it should be Glossary Access Point Agent Client Station Domain Gateway Dhcp Server Node IP Address MAC Address Manager Subnet Mask PacketsPing Routing 10Base-T port LEDs IndicatorsPower LED Fault LED Status LEDs MDI/MDI-X switch 10BaseT connector IO Connectors Serial Port connector Electrical Specifications Network ProtocolStandards Support Weight Physical SpecificationsEnvironmental Specifications Dimensions Electromagnetic Emissions Safety Agency Approvals Getting Technical Support Index 890-010 12/04/98 Data Encryption · 890-010 12/04/98 Logon page · 17 890-010 12/04/98 890-010 12/04/98 Enabling Data Encryption · Setting up · 25 serial devices · 890-010 12/04/98 890-010 12/04/98 RadioLAN