Ricoh 70 manual Lifting Tray Name

Message		Description	Corrective Action
Invalid Password		A valid password is required to access	Retry password. If incorrect, contact
		this area of the OCP.	your System Administrator.
Invalid Time Server Address		Incorrect value in time server IP	Check the time server IP address via
		address field.	the Web Utilities.
Invalid Value		Incorrect value entered.	Re-enter value.
LED Eraser Not Set		The LED eraser is not set.	Contact your authorized Service
Set Erase Lamp	E080		Technician.
Lifting Tray Name		The specified tray is moving into the	Status message. Wait for the printer to
		feed position.	return to a Ready state.
Loading Fail Network		Status message.	Wait for the printer to return to a Ready
			state.
Loading Network		Status message.	Wait for the printer to return to a Ready
			state.
Low on Front Staples		Status message.	Have replacement staples available.
Low on Rear Staples		Status message.	Have replacement staples available.
Low Toner - Recovery		In process of supplying the toner.	Wait for the printer to return to a Ready
	E09A		state.
MBT		The wrong paper size is loaded in the	Load the MBT with the requested
Load xx	E090	multi-bypass tray.	paper size.
Network Load Failed		Network connection error.	Check the Ethernet cable of the NIC.
Open Stacker Full		The output tray is full.	Remove the paper from the tray.
Out of Front Staples		The front stapler unit of the Finisher is	Replace the front staple cartridge.
Load Staples		out of staples.
Out of Rear Staples		The rear stapler unit of the Finisher is	Replace the rear staple cartridge.
Load Staples		out of staples.
Paper in Duplex Path		Paper jam on return path 1.	Remove the jammed paper.
Remove Paper	E05C
Paper in Fin Holding Path		Paper jam in holding path.	Remove the jammed paper.
Remove Paper
Paper in Fin Sheet Path		Paper jam in sheet path.	Remove the jammed paper.
Remove Paper
Paper in Finisher		Paper jam in entrance path of the	Remove the jammed paper.
Remove Paper	E064	Finisher.
Paper in Finisher		Paper jam in exit path of the Finisher.	Remove the jammed paper.
Remove Paper	E065
Paper in Finisher		Paper jam in bypass of the Finisher.	Remove the jammed paper.
Remove Paper	E066
Paper in Finisher		Paper jam in staple tray of the Finisher.	Remove the jammed paper.
Remove Paper	E067
Paper in Finisher		Paper jam in exit path of the Finisher	Remove the jammed paper.
Remove Paper	E068	sub tray.
Paper in Fuser		Paper jam in fuser unit.	Remove the jammed paper.
Remove Paper	E070
Paper in Input Station		Paper jam on IS path 1.	Remove the jammed paper.
Remove Paper	E050
Paper in Input Station		Paper jam on IS path 2.	Remove the jammed paper.
Remove Paper	E051

5-10 Troubleshooting

OG

L

0 1