Ricoh DSc424, DSc432, LD124c, LD132c Auto Colour Calibration, key, Note, Note, Note, [600, Note, [1800, [1200, ning], [Start], [Start], 600 dpi], 600 dpi], Press the, 1200 dpi], [Start Printing]

Troubleshooting

Auto Colour Calibration

If a certain colour is strong or the colour of the copy differs from the origi- nal, adjust the yellow, magenta, cyan and black balance.

Note

❒If "DToner is almost empty." is shown on the display panel, the test pattern cannot be printed.

A Press the {User Tools/Counter} key.

B Press [Maintenance].

6

C Press [Auto Colour Calibration].D Press [Start] on the “Copier Function ”.

Note

❒When performing the auto col- our calibration from the copy function, press [Start] under Copier Function. When per- forming from the printer func- tion, press [Start] under Printer Function.

E Press [Start Printing] and a test pattern will be printed.

Note

❒When performing the auto col- our calibration from the printer

function, select test patterns from [600 ⋅ 600 dpi], [1800 ⋅ 600 dpi] and [1200 ⋅ 1200 dpi] and then press [Start Printing].

❒The test pattern will be printed on an A4K, 81/2”⋅ 11”K size page (If A4K is not available then A3 L, B4 JISL will be used.). Make sure to check the paper set in the paper tray.

❒The counter will not proceed when the test pattern is printed.

F Place the test pattern on the exposure glass and press [Start Scan-

ning].

The image will be corrected after "Please wait." disappears.

Note

❒The test pattern will not be read if it is set in the ADF.

❒Set the test pattern in the follow- ing way:

AFT038S

❒When the ADF is installed, make sure to set the test pattern on the exposure glass, and then 2 or 3 white sheets, same size as the test pattern, above the test pattern.

136