Roland MV-8000 Editing a system exclusive message

110
Editing a song
Editing a system exclusive message
1.
Execute steps 1~4 of Using the
EVENT LIST EDIT screen to edit a
MIDI track (p. 106).
The EVENT LIST EDIT screen (p. 216) will
appear.
2.
Use (up/down) or the VALUE
dial to move to the system exclusive
message you want to edit.
3.
Press (right).
The EDIT SYS-EX popup will appear.
4.
Use (left/right) to move the cursor to the data you want to edit.
The cursor will move to successive bytes of the exclusive data.
5.
Use the VALUE dial or / to edit the value.
If you want to add a data byte to the exclusive message, move the cursor to the desired
location and press [F3 (Insert)]. A value of “00” will be inserted; edit the value as
desired.
If you want to delete a data byte from the exclusive message, move the cursor to that
location and press [F2 (Delete)].
6.
When you have finished editing, press (Execute).
The system exclusive message you edited will be finalized.
When you are inputting a Roland system exclusive message, you can use Auto Check Sum to
calculate the checksum automatically. If Auto Sum is On, the data byte preceding the end of the
message (F7) will be the checksum; the calculated result will be inserted here automatically. If
input is not successful, turn Auto Sum “Off” and then “On” again.
If you press [F4 (Test)], the system exclusive message you're editing will be transmitted from the
MIDI OUT connector.
When you use the up/down
cursor keys to move the
current time, the event located
at that time will be transmitted
from the MIDI OUT connector.
To specify the value of a
parameter, you can use the
VALUE dial or [DEC]/[INC],
or use the numeric keys to
input the value directly. After
using the numeric keys to
input a value, press [ENTER]
to finalize the input.
If you decide to stop editing a
system exclusive message and
discard the changes you made,
press [EXIT] to return to the
EVENT LIST EDIT screen.
ECS05_manual_e.book 110 ページ ２００５年１１月３０日 水曜日 午前１１時１４分