40
Sampling

9.

Press (OK).

The Quick Assign popup will appear.

10.

Strike the to which you want to assign
the sampled sound.

11.

Press (Set).

The sampled data will be assigned to the pad you struck. Now you can use this pad to
play the sampled sound.

If you are using the sampled sound as a patch, you can use the SMT (Sample Mix Table) to
combine sounds in complex ways. For details on using SMT, refer to

To create a partial that
combines more than one sample (SMT)

(p. 58).

Convenient options during sampling

By setting various options in the Sampling screen you can change the behavior of
sampling.

Make preparations for sampling.

As described in step 5 of

Using a sampled sound as an audio phrase or patch

(p.
38), set the parameters appropriately for your purpose.

Sample in stereo

➜

Set the Sampling Type parameter to Stereo.

The audio source will be sampled in stereo. However, the following conditions apply
to stereo-sampled data.
• The stereo sampled data occupies twice as much space as monaural data.
• Playing a stereo sample will consume two voices of polyphony.

Start sampling in synchronization with the audio source input

➜

Set the Start Trigger and Trigger Level values.

If you set the Start Trigger parameter to “Level,” sampling will be triggered by the
input sound.
The Trigger Level parameter specifies the sensitivity of the Start Trigger function.
Lower values will produce higher sensitivity, meaning that even a small sound will
trigger sampling.

Sample without losing the sharp attack of a sound

➜

Set the Pre Sample Time parameter value.

Increasing the Pre Sample Time parameter value will cause sampling to capture the
If you want to assign the
sample to a different bank,
switch the bank before you
strike a pad. For details on
how to switch pad banks,
refer to To switch to a
different pad bank (p. 73).
When you adjust the level of
the Start Trigger, a will
appear at the right of the level
meter. Sampling will begin
when the input level exceeds
this mark.
With a setting of Pre Sample
Time=0, recording will begin
the instant that sampling is
initiated; i.e., the Pre Sample
Time will have no effect.
ECS05_manual_e.book 40 ページ ２００５年１１月３０日　水曜日　午前１１時１４分