178

System settings for the MV-8000

Settings for the entire MV-8000 (Global)

Here's how to make settings that affect the overall operation of the MV-8000.

Accessing the Global screen

1.
Press .
The
SYSTEM MENU screen
(p. 319) will appear.
2.
With the cursor located in the upper row of icons, press (Global).
Alternatively, select the GLOBAL icon and press .
The
GLOBAL screen
(p. 320) will appear.
Setting the basic pitch (Master Tune)
Here's how to set the overall tuning of the MV-8000. This is specified as the frequency
of the A4 note (middle “A” on a piano).
1.
Access the GLOBAL screen as described in
Accessing the Global screen
(p. 178).
2.
Set the Master Tune parameter.
This specifies the pitch of the A4 note. Increasing this value will raise the pitch, and
decreasing this value will lower the pitch. Normally you will leave this at 440.0 Hz.
Setting the audition time (Preview Length)
The “Preview function” lets you listen to the recorded sound immediately after
sampling. The Preview Length parameter sets the playback time of this Preview
function.
1.
Access the GLOBAL screen as described in
Accessing the Global screen
(p. 178).
2.
Set the Preview Length parameter.
You can set this value (playback time) in steps of 0.1 seconds over a range of 0.1~10.0
seconds.
Specifying the digital output source
This setting selects the audio source that will be output from the rear panel digital out
(DIGITAL A and B) connectors.
1.
Access the GLOBAL screen as described in
Accessing the Global screen
(p. 178).
2.
Set the Digital Output Select parameter.
Select the bus that you want to output. If you select Master, the audio of the entire
MV-8000 (the mix bus) will be output.
For details on all
parameters, refer to
GLOBAL screen (p. 320).
The audio signal of the exact
same bus is output from
DIGITAL A and B. You cannot
choose the output bus
independently for each
connector.
ECS05_manual_e.book 178 ページ ２００５年１１月３０日　水曜日　午前１１時１４分