279
INSTRUMENTS

Common items in all screens SEQUENCE SONG SETUP INSTRUMENTS AUDIO PHRASES

SAMPLE EDIT screen

Here you can edit the sample used by the partial.

To access this screen

•

➜➜➜
INSTRU-
MENTS

Explanation of each area

1.

SMT Number (Sample Mix Table number)

Of the samples (SMT) that make up the
currently-edited partial, this specifies the SMT
number that you are actually editing. In the example
shown here, you are editing SMT1 of the two (SMT1
and 2) that make up the partial.
Range: 1~4

2.

Sample

Displays the number and name of the sample you are
editing.

3.

SMT (Sample Mix Table)

This shows the structure of the samples that make up
the partial selected in 1. In the example shown here,
the partial consists of SMT1 and 2.

4.

Wave window

Displays the sample (waveform) you are editing.
When you edit parameters 6~10, this area will show
the setting of each point.

5.

Start Point

Specifies the point at which playback will start. Set
this to skip any unwanted portion at the beginning of
the sample, so that the sound will play at the desired
timing.

6.

Loop Point

Specifies the point at which the playback will begin
repeating (i.e., for the second and subsequent plays).
Set this if you want to the sample to loop from a point
other than the Start Point.

7.

End Point

Specifies the point at which playback will end. Set
this to avoid playing any unwanted portion at the
end of the sample.

8.

Zoom Level

This indicates the magnification of the waveform
shown in the wave window.
is the horizontal (time axis) magnification, and
is the vertical (level axis) magnification.

9.

Loop Mode

Specifies how the sample will play.

Value Explanation

Forward
The sample will play from the start
point to the end point, and then repeat-
edly play from the loop start point to the
end point in the forward direction.
One Shot
The sample will play once from the start
point to the end point.
Start Point Loop Point End Point
Start Point Loop Point End Point
ECS05_manual_e.book 279 ページ ２００５年１１月３０日　水曜日　午前１１時１４分