116
Effect/Parameter List
18: AUTO PAN
Cyclically modulates the stereo location of the sound.
19: STEP PAN
This uses a 16-step sequence to vary the panning of the sound.
20: SLICER
By applying successive cuts to the sound, this effect turns a
conventional sound into a sound that appears to be played as a
backing phrase. This is especially effective when applied to sustain-
type sounds.
21: ROTARY
The Rotary effect simulates the sound of the rotary speakers often
used with the electric organs of the past. Since the movement of the
high range and low range rotors can be set independently, the unique
type of modulation characteristic of these speakers can be simulated
quite closely. This effect is most suitable for electric organ Patches.
Rate Mode Hz, note When this is set to “note,” the effect is
synchronized with the tempo.
Rate (Hz) 0.05–10.00
Hz
Frequency of the change (Hz)
Rate ( ) note (*1) Frequency of the change (note)
Depth 0–127 Depth to which the effect is applied
Low Gain -15– +15 dB Gain of the low range
High Gain -15– +15 dB Gain of the high range
Level 0–127 Output Level
Assignable Parameters
MFX Control Rate, Depth, Mod Wave
Parameter Value Description
Mod Wave TRI, SQR,
SIN, SAW1,
SAW2
Modulation Wave
TRI
: triangle wave
SQR
: square wave
SIN
: sine wave
SAW1/2
: sawtooth wave
Rate Mode Hz, note When this is set to “note,” the effect is
synchronized with the tempo.
Rate (Hz) 0.05–10.00
Hz
Frequency of the change (Hz)
Rate ( ) note (*1) Frequency of the change (note)
Depth 0–127 Depth to which the effect is applied
Low Gain -15– +15 dB Gain of the low range
High Gain -15– +15 dB Gain of the high range
Level 0–127 Output Level
Assignable Parameters
MFX Control Rate, Attack
Parameter Value Description
Step 01–16 L64–63R Pan at each step
Rate Mode Hz, note When this is set to “note,” the effect is
synchronized with the tempo.
Rate (Hz) 0.05–10.00
Hz
Rate at which the 16-step sequence will
cycle (Hz)
Rate ( ) note (*1) Rate at which the 16-step sequence will
cycle (note)
Attack 0–127 Speed at which the pan changes
between steps
Input Sync Sw OFF, ON Specifies whether an input note will
cause the sequence to resume from the
first step of the sequence (ON) or not
(OFF)
Input Sync
Thres
0–127 Volume at which an input note will be
detected
Level 0–127 Output volume
Parameter Value Description
SAW1 SAW2
L
R
L
R
Assignable Parameters
MFX Control Rate, Attack, Shuffle
Parameter Value Description
Step 01–16 0–127 Level at each step
Rate Mode Hz, note When this is set to “note,” the effect is
synchronized with the tempo.
Rate (Hz) 0.05–10.00
Hz
Rate at which the 16-step sequence will
cycle (Hz)
Rate ( ) note (*1) Rate at which the 16-step sequence will
cycle (note)
Attack 0–127 Speed at which the level changes
between steps
Input Sync Sw OFF, ON Specifies whether an input note will
cause the sequence to resume from the
first step of the sequence (ON) or not
(OFF)
Input Sync
Thres
0–127 Volume at which an input note will be
detected
Mode LEGATO,
SLASH
Sets the manner in which the volume
changes as one step progresses to the
next.
LEGATO
: The change in volume
from one step’s level to the next
remains unaltered. If the level of a
following step is the same as the one
preceding it, there is no change in
volume.
SLASH
: The level is momentarily set
to 0 before progressing to the level of
the next step. This change in volume
occurs even if the level of the
following step is the same as the
preceding step.
Shuffle 0–127 Timing of volume changes in levels for
even-numbered steps (step 2, step 4,
step 6...).
The higher the value, the later the beat
progresses.
Level 0–127 Output level
Assignable Parameters
MFX Control Speed, Tw Fast Rate, Wf Fast Rate, Separation
Parameter Value Description
Speed SLOW, FAST Simultaneously switch the rotational
speed of the low frequency rotor and
high frequency rotor.
SLOW
: Slows down the rotation to
the Slow Rate.
FAST
: Speeds up the rotation to the
Fast Rate.
Wf Slow Rate 0.05–10.00
Hz
Slow speed (SLOW) of the low
frequency rotor
Wf Fast Rate 0.05–10.00
Hz
Fast speed (FAST) of the low frequency
rotor
RD-700SX_e.book 116 ページ 2006年3月23日 木曜日 午後2時52分