99
Detailed Settings for Each Function ([EDIT])
Bulk Dump Temporary
6.
Press CURSOR [ ].
A screen like the one shown below appears.
fig.05-30g
7.
Put the external sequencer in record mode.
8.
Press [ENTER] to transmit the settings.
To cancel the Bulk Dump, press [DEC].
The message “Now, Executing...” appears in the display during
transmission of the data.
9.
After the transmitting is finished, the display will
indicate “COMPLETE!.”
You are returned to the Edit screen.
10.
Stop the external sequencer.
Bulk Dump SETUP
6.
Press CURSOR [ ].
A screen like the one shown below appears.
fig.05-31g
7.
Press CURSOR [ ] / [ ] and [INC]/[DEC] to set
the transmitted Setups.
8.
Put the external sequencer in record mode.
9.
Press [ENTER] to transmit the settings.
To cancel the Bulk Dump, press [DEC].
A screen like the one shown below appears.
fig.05-33g
10.
After the transmitting is finished, the display will
indicate “COMPLETE!.”
You are returned to the Edit screen.
11.
Stop the external sequencer.
Restoring saved settings to the RD-700SX
When returning settings saved to an external sequencer back to the
RD-700SX, an Exclusive message is transmitted from the external
sequencer, then the data is received by the RD-700SX.
Be aware that when you restore Setups data to the RD-700SX,
the data in the RD-700SX will be overwritten and lost.
1.
Use a MIDI cable to connect the MIDI OUT connector
of the external sequencer to the MIDI IN connector of
the RD-700SX.
2.
Set the device ID number to the same setting as
when you performed the bulk dump.
Setting the Device ID Number `
“Setting the Device ID
Number (Device ID)”
(p. 81).
3.
Make sure that [EDIT] indicator is extinguished.
If the [EDIT] indicator is lit, press [EDIT] to turn the indicator
light off and put the RD-700SX in normal performance mode.
4.
Transmit (play back) the data from the external
sequencer.
After playback of the Bulk Dump SETUP data, the RD-
700SX writes the data to the internal memory. Be sure
never to turn off the power while this data is being written
(while “Now, writing Bulk Dump Data. Keep on POWER!” is
showing).
For details on transmitting exclusive data, refer to the owner’s
manual for your sequencer.
Play back the external sequencer at the same tempo you used
when performing the bulk dump. If you use a faster tempo, the
data may not be restored correctly.
Data cannot be received if the Device ID of the receiving device
differs from the Device ID used when Bulk Dump was carried
out.
Parameter Value
From Setup number for the first Setup to be
transmitted.
To Setup number for the last Setup to be
transmitted.
Send System Determines whether the system settings
are to be transmitted (YES), or not (NO).
RD-700SX_e.book 99ページ ２００６年３月２３日　木曜日　午後２時５２分