121
Effect/Parameter List
35: OVERDRIVE

Creates a soft distortion similar to that produced by vacuum tube
amplifiers.

36: DISTORTION

Produces a more intense distortion than Overdrive. The parameters
are the same as for “35: OVERDRIVE.”

37: VS OVRDRIVE (VS OVERDRIVE)

This is an overdrive that provides heavy distortion.

38: VS DIST(VS DISTORTION)

This is a distortion effect that provides heavy distortion. The
parameters are the same as for “37: VS OVERDRIVE.”

39: GTR AMP SIM (GUITAR AMP SIMULATOR)

This is an effect that simulates the sound of a guitar amplifier.

Specifications of each Speaker Type

The speaker column indicates the diameter of each speaker unit (in
inches) and the number of units.
Hi Feedback -98– +98% Proportion of the high-range flanger
sound that is to be returned to the input
(negative values invert the phase)
HiStp Mode Hz, note When this is set to “note,” the effect is
synchronized with the tempo.
HiStp Rt(Hz) 0.10–20.00
Hz
Rate at which the steps will cycle for the
high-range flanger sound (Hz)
HiStp Rt( ) note (*1) Rate at which the steps will cycle for the
high-range flanger sound (note)
Balance D100:0W–
D0:100W
Volume balance of the original sound
(D) and flanger sound (W)
Level 0–127 Output volume

Assignable Parameters

MFX Control Level, Amp Type, Drive, Pan

Parameter Value Description

Drive 0–127 Degree of distortion
Also changes the volume.
Amp Type SMALL,
BUILT-IN,
2-STACK,
3-STACK
Type of guitar amp

SMALL

: small amp

BUILT-IN

: single-unit type amp

2-STACK

: large double stack amp

3-STACK

: large triple stack amp
Low Gain -15– +15 dB Gain of the low range
High Gain -15– +15 dB Gain of the high range
Pan L64–63R Stereo location of the output sound
Level 0–127 Output Level

Assignable Parameters

MFX Control Level, Tone, Amp Type, Drive, Pan

Parameter Value Description

Drive 0–127 Degree of distortion
Also changes the volume.
Tone 0–127 Sound quality of the Overdrive effect
Amp Sw OFF, ON Turns the Amp Simulator on/off.
Amp Type SMALL,
BUILT-IN,
2-STACK,
3-STACK
Type of guitar amp

SMALL

: small amp

BUILT-IN

: single-unit type amp

2-STACK

: large double stack amp

3-STACK

: large triple stack amp
Low Gain -15– +15 dB Gain of the low range
High Gain -15– +15 dB Gain of the high range
Pan L64–63R Stereo location of the output sound
Level 0–127 Output Level

Parameter Value Description

Assignable Parameters

MFX Control Pre Amp Master, Pre Amp Volume, Pre Amp, Speaker

Parameter Value Description

Pre Amp Sw OFF, ON Turns the amp switch on/off.
Pre Amp JC-120,
CLEAN
TWIN,
MATCH
DRIVE,
BG LEAD,
MS1959I,
MS1959II,
MS1959I+II,
SLDN LEAD,
METAL5150,
METAL
LEAD,
OD-1,
OD-2 TURBO,
DISTORTION,
FUZZ
Type of guitar amp
Pre Amp
Volume
0–127 Volume and amount of distortion of
the amp
Pre Amp
Master
0–127 Volume of the entire pre-amp
Pre Amp Gain LOW,
MIDDLE,
HIGH
Amount of pre-amp distortion
Pre Amp Bass 0–127 Tone of the bass/mid/treble
frequency range

* Middle cannot be set if “Match Drive”
is selected as the Pre Amp Type.

Pre Amp
Middle
Pre Amp Treble
Pre Amp
Presence
0–127
(MATCH
DRIVE:
-127 – 0)
Tone for the ultra-high frequency
range
Pre Amp Bright OFF, ON Turning this “On” produces a sharper
and brighter sound.

* This parameter applies to the “JC-
120,” “Clean Twin,” and “BG Lead”
Pre Amp Types.

Speaker Sw OFF, ON Determines whether the signal passes
through the speaker (ON), or not
(OFF).
Speaker (See the table
below.)
Type of speaker
Mic Setting 1, 2, 3 Adjusts the location of the mic that’s
capturing the sound of the speaker.
This can be adjusted in three steps,
from 1 to 3, with the mic becoming
more distant as the value increases.
Mic Level 0–127 Volume of the microphone
Direct Level 0–127 Volume of the direct sound
Pan L64–63R Stereo location of the output
Level 0–127 Output level

Type Cabinet Speaker Microphone

SMALL 1 small open-back enclosure 10 dynamic
SMALL 2 small open-back enclosure 10 dynamic
MIDDLE open back enclosure 12 x 1 dynamic
JC-120 open back enclosure 12 x 2 dynamic
RD-700SX_e.book 121 ページ ２００６年３月２３日　木曜日　午後２時５２分