Roland RD-700SX , , , , Restoring the Factory Settings (Factory Reset)

25
Getting Ready
When using the RD-700SX for the first time, start by returning the settings to their
factory defaults so that the RD-700SX operates as described in the procedures in the
owner’s manual.
fig.00-12p
1
Press [EDIT], getting the indicator to light.
The Edit Menu screen appears.
fig.00-13g
2
Press CURSOR [ ] to select “9.Utility.”
3
Press [ENTER] to display the Utility screen.
fig.00-14g
4
Press CURSOR [ ] to select “Factory Reset All.”
Restoring the Factory Settings (Factory Reset)
Executing this operation
deletes the Setup settings (p.
56). If you want to keep any
internally stored content, use
the “Bulk Dump (Bulk Dump
SETUP)” procedure to save the
data to an external sequencer
(p. 99).
Notes
Never turn off the power during Factory Reset (while “Now, Executing”
appears in the display).
Turning off the power while Factory Reset is in progress may result in
corrupted internal data and may prevent the power from being turned on again. If
you have confirmed that the internal data has been lost, or if a similar problem exists,
consult the retailer from whom you purchased the instrument, or the nearest Roland
Service Center. Note, however, that Roland assumes no liability, including
compensation, for consequences arising from any loss of data.
12,43,5,6,7
When making USB
connections, be absolutely
sure to disconnect the USB
cable before starting.
Instead of selecting with the
CURSOR, you can press TONE
SELECT [9] to display the
Utility Edit screen directly.
RD-700SX_e.book 25ページ ２００６年３月２３日 木曜日 午後２時５２分