RuggedCom RS400 manual Mode, Set Rate DS/US

Ethernet Ports

Figure 76: EoVDSL Parameters Form

Port

Synopsis: 1 to maximum port number

Default: Depends on the particular product (3 for RS920L, 7 for RS930L, 9 for RS9XX, etc.) The port number as seen on the front plate silkscreen of the switch.

Type

Synopsis: { Univ, LR }

The type of VDSL port. Supported types: Universal and Long Reach.

Mode

Synopsis: { Master, Slave }

Default: Master

Specify if the port should operate as a VDSL Master or Slave. Note that for Long-reach VDSL port, “Mode” is pre-determined by hardware and cannot be changed by user.

Set Rate (DS/US)

Synopsis (Universal VDSL):

{Auto, 35.2/35.2 Mbs, 30.2/30.2 Mbs, 25.3/25.3 Mbs, 20.1/20.1 Mbs, 15.4/15.4 Mbs, 10.1/10.1 Mbs, 5.1/5.1 Mbs, 2.7/2.7 Mbs, 1.2/1.2 Mbs }

Synopsis (Long-reach VDSL):

{Auto, 40.0/20.3 Mbs, 25.3/5.1 Mbs, 20.1/0.5 Mbs, 15.2/0.5 Mbs, 10.1/0.5 Mbs, 5.1/0.5 Mbs, 2.2/0.5 Mbs, 1.2/0.5 Mbs, 0.5/0.2 Mbs }

Default: Auto

Specify required down-stream (Master-to-Slave) and up-stream (Slave-to-Master) bit rate.

If this parameter is set to 'Auto', the system will automatically find the highest rate supported for

RS400 107 ROS™ v3.5