RuggedCom RS400 manual Serial Protocols Port, ForceHD, Baud, Data Bits, Stop, Parity, Pack Timer

Serial Protocols

Port

Synopsis: 1 to maximum port number

Default: 1

The port number as seen on the front plate silkscreen of the switch.

Name

Synopsis: Any 15 characters

Default: Port 1

A descriptive name that may be used to identify the device conected on that port.

Protocol

Synopsis: { None, RawSocket, ModbusServer, ModbusClient, DNP, WIN, TIN, MicroLok,

MirroredBits,PreemptRawSocket }

Default: None

The serial protocol supported on this serial port.

Type

Synopsis: { RS232, RS485, RS422, FIBER }

Default: RS232

A serial port interface type.

ForceHD

Synopsis: { On, Off }

Default: Off

Enables forcing half duplex mode of operation. While sending data out of the serial port all received data are ignored. This mode of operation is available only on ports that operate in full duplex mode.

Baud

Synopsis: 100 to 230400

Default: 9600

The baud rate at which to operate the port.

Data Bits

Synopsis: { 7, 8 }

Default: 8

The number of data bits to operate the port with.

Stop

Synopsis: { 1, 1.5, 2 }

Default: 1

The number of stop bits to operate the port with.

Parity

Synopsis: { None, Even, Odd }

Default: None

The parity to operate the port with.

Pack Timer

Synopsis: 5 to 1000

Default: 10 ms

The delay from the last received character until when data is forwarded.

Turnaround

Synopsis: 0 to 1000

RS400 69 ROS™ v3.5