RuggedCom RS400 manual Read Power Supply Status from device using PSStatusCmd, See ROS

Index

Values used for presenting power supply status have been derived from RuggedCom specific MIB for SNMP.

Read Power Supply Status from device using PSStatusCmd:

E.g. A Modbus Request to read multiple registers from location – 0x0043

0x04 0x00 0x43 0x00 0x01

Response may look like:

0x04

0x02 0x00 0x0A

In the above response lower byte of the register shows status of power supplies. As per the response both power supplies in the unit are functional.

Index
Alarms
Active Alarms		238
Critical Failure Relay		238
Passive Alarms		238
Using Alarms		237
CLI Shell Command
clearlogs		247
dir		246
help		246
ipconfig		249
ping		247
reset		250
Summary		245
trace		247
type		246
Configuration
TFTP Capture		254
XModem Capture		254
CoS
Configuration		187
CoS (Classes of Service) Operation		185
DSCP		191
DHCP Relay		48
Diagnostics
CPU Diagnostics		239
Product Information		242
System Log		241
DNP Configuration		80
DSCP	See CoS:DSCP
Ethernet
Link Detection		102

Loss-of-Link Management		93
PoE		103
Port Configuration		93, 95
Port Mirroring		100
Port Rate Limiting		99
Resetting Ports		109
Troubleshooting Ports		109
Factory Default Configuration, Loading		........243
FEFI		93
Firmware
TFTP Client Upgrade		253
TFTP Server Upgrade		252
XModem Upgrade		251
GVRP	See VLAN:GVRP
IGMP		195
Active and Passive Mode		196
Configuration		200
Consumers and Producers		195
general membership query		196
group-specific membership query		196
leave group message		196
membership report		196
Operation		195
Interface	See ROS
Layer 3 switches, Using		169
LLDP		213
Configuration		214
Operation		213
MAC Addresses
Configuring		209
Learning Options		209

RS400 273 ROS™ v3.5