Runco LS-HB operation manual Using Picture-In-Picture PIP, PIP Input Source

Operation

4.4 Using

Picture-In-Picture (PIP)

For PIP purposes, there are three groups of inputs
separated by their display modes:	PIP	SWAP	LIGHT

•Video (SD) group: Video, S-Video and SCART inputs.

•Graphic (HD) group: Component 1 and RGB inputs.

•Digital Video group: HDMI 1 and HDMI 2 inputs.

PIP shows one input from any of these groups within or beside one input from either of the other two groups.

•Press PIP to enable the PIP function. Once enabled, press PIP repeatedly to select the desired PIP source or turn PIP off.

•Press SWAP to swap the main and PIP images.

For more information, refer to PIP Position on page 64.

For each source, Table 4-1shows which of the other sources are available as a PIP source.

Table 4-1. Available Main and PIP Source Combinations

				PIP Input Source
		VIDEO	S-VIDEO	SCART	COMP 1	RGB	HDMI 2	HDMI 1
	VIDEO	–	–	–	√	√	√	√
	S-VIDEO	–	–	–	√	√	√	√
		–	–	–	√	√	√	√
Main SourceInput	COMPSCART1	√	√	√	–	–	√	√
		√	√	√	–	–	√	√
	RGB
	2
	HDMI	√	√	√	√	√	–	–
	1
	HDMI	√	√	√	√	√	–	–

Notes:

1. “√” means that that source is available as a PIP source with a given main source; “–” means that it is not.

2. Disabled sources (refer to Source Enable on page 63) are not available as PIP sources.

46 Runco LS-HB Installation/Operation Manual