Runco LS-HB operation manual same frame rate as the main source, Standard for your region

Operation

Video Standard: Select Video Standard from the Advanced menu to specify the color system for composite video or S-Video input signals.

Different countries use different formats for video signals. Select the appropriate Video

Standard for your region:

•Auto: The color systems are automatically identified and the format is set accordingly.

•PAL: This is the standard used in Europe, Australia and many other parts of the world, typically with a 50Hz frame rate.

•SECAM: This is a standard format used mainly in France and Russia.

•NTSC: This is the standard format used mainly in the United States and Japan.

Gamma: Select Gamma from the Advanced menu to choose a DLP de-gamma curve. Used correctly, the Gamma control can improve contrast while maintaining good details for blacks and whites.

If excess ambient light washes out the image and it becomes difficult or impossible to see details in dark areas, lower the gamma setting to compensate. This improves contrast while maintaining good details for blacks. Conversely, if the image is washed out and unnatural, with excessive detail in black areas, increase the setting.

•2.5 sets the gamma to a 2.5 power law.

•2.2 sets the gamma to a 2.2 power law.

•Video is similar to 2.2 gamma but differs in dark areas of the image to correspond to the function that video cameras use to create images.

•2.0 sets the gamma to a 2.0 power law. This is the default setting.

DLP Frame Rate: Select DLP Frame Rate from the Advanced menu to choose the output frame rate. You can have the LS-HB automatically determine the optimum frame rate, or you can force it to use a specific frame rate.

Note	If PIP is active, the LS-HB converts the PIP source frame rate to the
	same frame rate as the main source.

•The default setting, Auto, frame locks to the main source if it has a vertical refresh rate of between 48 and 62Hz. Vertical refresh rates of from 24 to 31Hz are doubled. Frame rates between 31 and 48Hz and greater than 62Hz are converted to 60Hz.

•Select 48Hz to force the output frame rate to 48Hz. Use this setting to eliminate 2:3 pull-down judder with 60Hz film-based sources.

•50Hz and 60Hz force the output frame rate to 50Hz and 60Hz respectively.

SatCo: SatCo controls the lamp waveform and affects the output image as follows:

•Off (Red Boost): Reduced yellow and white, slightly increased red.

•Low (White Boost): Increased yellow and red.

•High (White Boost): Increased yellow and white. This is the default setting.

Adaptive Contrast: Adaptive Contrast enhancement expands the light and dark portions of an output image according to the mean luminance of the input image.

Runco LS-HB Installation/Operation Manual 59