Sam4s ER-390M manual Program Scans, PLU Program Scan

Program Scans

Since much time and energy has been invested in the planning and programming of your ER-390M, it is advisable to print a hard copy of the final program for future reference. This copy should be kept in a safe place.

1.Turn the control lock to the P position.

2.To print a program scan, enter 1 5, press the SBTL key.

1 5 SBTL

3.In this step, there are three different ways to scan program information. One is PLU, the other is Macro, and the third is Others.

PLU PROGRAM SCAN

To read single PLU program information, enter the number (1-1000) of the PLU and press the same number and PLU key.

Enter the PLU#,	PLU	Enter the PLU#,	PLU
up to 15 digits		up to 15 digits

Press a PLU key on the keyboard and press same key again.

PLU 1 PLU 1

To read multiple PLU program information, enter the first number (1-1000) and press PLU key. Press the last number (1-1000) and press PLU key

Enter the first		Enter the last
PLU#, up to 15	PLU	PLU#, up to 15	PLU
digits		digits
Press a PLU key on the keyboard.
PLU 1	PLU 10

MACRO PROGRAM SCAN

To read MACRO information, press the MACRO key to be scanned,

MACRO# MACRO#

Refer to the chart below and enter a digit to represent the segment of the program you wish to print; press the X/TIME key. To see additional scan, repeat this operation.

ER-390M Program Mode Programming • 167