7Press the Upper Level button ( ), then use the scroll button ( ).

8Press the Enter button ( ) when ‘IP Get Method’ displays.

9Press the scroll button ( or ) to display ‘DHCP’ and press the Enter button ( ).

10 To assign the address from the BOOTP server, press the Enter button ( ) when “BOOTP” displays.

11 Press the On Line/Continue button ( ) to return to ready mode.

Configuring IPX Frame Types

On IPX/SPX protocol networks (for example, Novell NetWare), the format of the network communication frames must be specified for the printer. In most cases, you can keep the default setting ‘Auto’. However, you can manually set the frame type format, if required.

Auto (default): Automatically senses and limits the frame type to the first one detected.

EN_8023: Limits the frame type to IPX over IEEE 802.3 frames. All others will be discarded.

EN_II: Limits the frame type to IPX over Ethernet Frames. All others will be discarded.

EN_8022: Limits the frame type to IPX over IEEE 802.2 with IEEE 802.3 frames. All others will be discarded.

EN_SNAP: Limits the frame type to IPX over SNAP with IEEE 802.3 frames. All others will be discarded.

Note that the IPX/SPX protocol must be enabled in the Netware menu before you can configure frame types. See “Setting Network Protocols” on page B.7.

B.10 USING YOUR PRINTER ON A NETWORK

Page 212
Image 212
Samsung 500N setup guide Configuring IPX Frame Types