Preparation for installation

1When moving with a crane

––Fasten the wire rope as shown in the figure.

––To protect damage or scratches, insert a piece of cloth between the outdoor unit and the wire rope.

2When moving with a forklift

––Carefully insert the forklift forks into the forklift holes at the bottom of the outdoor unit.

––Be careful with the forklift from damaging the product.

3When moving the product without wooden pallet and the crane is not available for use

––Connect a wire rope to the outdoor unit as you would move it with a crane.

––Hang the wire rope to the forklift fork to move the outdoor unit.

Wire rope

Wooden pallet

Deciding on where to install the product

Indoor unit

PARTS INSTALLATION

•Install the unit at a place close to the wall facing the outside as it is necessary to perform piping connection with the outdoor unit.

––It is effective to install the unit at a window side to ensure uniform distribution of indoor temperature.

•Install the unit at a place where there is no obstacle against the wind around the air intake and air outlet.

•Install the unit horizontally at a stable, rigid place. (When installing the unit at a place subjected to oscillation, noise may occur.)

•Avoid a place near the door which is frequented by people.

•Avoid a place subject to direct sunlight.

•Avoid a place with high humidity. Dew may form during cooling operation. (Near kitchen)

Top view

Front

More than 600mm

Side view

More than 600mm

Air outlet

Front

Air inlet

More than 1000mm

34English