Mechanical Disassembly

top of the liner, and slide the ice maker in.

5. Tighten the screws (2) of the ice maker support.

Auger Motor Case

The ice maker is located inside of the ice dispenser assembly.

1.Remove ice maker support screws (2), and slide out.

2.Disconnect the ice maker wire connector.

3.Unlock the locking tabs to separate the ice maker kit.

In order to assemble the icemaker kit.

1.Assemble the geared motor shaft and the front of ice tray.

2.Lift the front locking tab and assemble the ice maker kit.

3.Connect the ice maker wire connector.

4.Match the tab holes and tabs(2) located on the

This shelf is designed to support the ice maker ice dispensed and Xtra SpaceTM.

1.Remove the Xtra SpaceTM cover to push it down near the partition.

2.Slide the partition out.

3.Remove the screws (2) on the bottom front of the case.

4.Slide out the case while disconnecting the wire connect.

Partition

Screws

19

Page 19
Image 19
Samsung RS2777, RS2544, RS2666, RS2622 manual Auger Motor Case, Ice maker is located inside of the ice dispenser assembly