Samsung SCC-C6475P manual Camera SET Menu, Sync, Camera ID, Means there are Sub Menus

❈If the power is turned off after PRESET, AUTO PAN, SCAN, PATTERN function is activated and no other control is made, camera will do the same function after the power is turned on.

❈Menu setting is available only when tilt position is under 90°. When tilt position is over 90° and menu-on command is received, pan will automatically rotate 180° and tilt will be move to the corresponding position.

Use the controller to press the MENU selection key and the following

(CAMERA SET)
CAMERA ID	ON...	➜
V-SYNC	INT
COLOR/BW	COLOR	Press
MOTION DET	OFF
ZOOM SPEED	3	[Enter]
DIGITAL ZOOM	OFF
EXIT	QUIT

* " ... " Means there are Sub Menus.

(CAMERA ID)

AB C D E F G H I J K L M N O PQ R S T U V W X Y Z 0 1 2 3 4 5 6 7 8 9

:! - + ✽ ( ) /

SP ï î SP LOCATION...

RET

SCC-C6475(P)........

E

screen will be displayed.

V-SYNC

* * MAIN MENU * *

CAMERA SET...

VIDEO SET...

PRESET ...

ZONE SET...

AUTO SET...

ALARM SET...

OTHER SET...

SYSTEM INFO...

➀PASSWORD UNDEFINED

0 1 2 3 4

5 6 7 8 9

✽ ✽ ✽ ✽

➁PASSWORD DEFINED

In the V-SYNC menu, vertical synchronization can be selected. The vertical synchronization signal supported by the SCC-C6475(P) is the INT mode made by clock inside the SCC-C6475(P) and LINE mode adjusting vertical synchronization to the exterior power frequency.

Select LINE and press [Enter]. You will see the LINE LOCK submenu where you can adjust the phase of the LINE LOCK.

You can use the PHASE menu of the LINE LOCK submenu to assign as much PHASE as you want.

(CAMERA SET)

(LL-PHASE)

In case of ➀, use UP/DOWN/LEFT/RIGHT/[ENTER] key for MENU setup. In case of ➁, type in the 4 digit password first. If correct, the MENU selection screen like ➀ will be displayed and you will be able to set up MENU by pressing UP/DOWN/LEFT/RIGHT/[ENTER] key.

1. CAMERA SET MENU

CAMERA ID

The CAMERA ID menu assigns an ID to the SCC-C6475(P) to be displayed on the connected monitor.On the CAMERA SET menu screen, select CAMERA ID to ON and press [Enter]. You will see the sub screen for deciding on the ID of the SCC-C6475(P). The Camera ID can have up to 20 alphanumeric characters, along with several special characters.

The assigned camera ID may be positioned to any desired location on the screen by using the LOCATION submenu.

Caution CAMERA ID OSD is not displayed in the network viewer.

CAMERA ID	OFF
V-SYNC	LINE...
COLOR/BW	COLOR
MOTION DET	OFF
ZOOM SPEED	3
DIGITAL ZOOM	OFF
EXIT	QUIT

➜

Press [Enter]

PHASE (000)----I----

RET

4-4 4-5