Samsung SSA-S2100/EXP manual Duress Mode, To delete all registered master IDs, Master ID CLR

user management

TO REMOVE THE MASTER IDs

If you want to remove all master IDs (card IDs), use this menu.

1.Press the F8 SETUP MENU button.

2.	Use the buttons	4	and 6 to move to the MASTER ID CLR item and
	press ENT .
3.	Press the button	1	to delete all registered master IDs.

• To cancel the work, press the button 0 .

J Before removing all master IDs, ensure that the master IDs are no longer in use.

DURESS MODE

4. MASTER ID CLR

4.MASTER ID CLR

1:YES, 0:NO

You can set Duress Mode for READER#1. Duress mode is a special feature that outputs a special alarm signal when a it is forced to open the restricted area, whose default is NOT USE. When selecting USE, you are prompted to enter the two-digit numbers for the Duress mode password, whose default is ‘00’.

If it is set to USE, enter the two-digit Duress password and press ENT ; this will open the door normally, but the Duress alarm signal is transmitted to the host PC.

1. Press the F2 SETUP MENU button.

2.	Use the buttons	4	and	6	to move to the DURESS MODE item and
	press ENT .
3.	Use the buttons	4	and	6	to select USE.

•€ NOT USE : Duress Mode is disabled.

€ USE : If set to USE, proceed with the followings:

4.The DURESS password is shown. Press ENT .

5.Enter the two-digit password and press ENT .

M The Duress Mode password should be different from the Arm/Disarm code.

You can specify the output time for each signal out for Duress Alarm. (See Page 43 for “Duress Mode Output Setup”.)

6.DURESS MODE

J NOT USE

6.DURESS MODE

JUSE

DURESS PASSWORD

00

ENTER DURESS P/W

█

36_ user management