Sanyo KGS1411, CG1411 Operation with the Remote Control Unit continued, Adjusting the Fan Speed

Operation with the Remote Control Unit (continued)

NOTE

3.Adjusting the Fan Speed

A.Automatic

Cooling and DRY mode:

Heating mode:

NOTE

B. Manual

·Choose the best position in the room for the remote control unit, which also acts as the sensor for room comfort and transmits the operating instructions. Once you've found this best position, always keep the remote control unit there.

·This appliance has a built-in 3-minute time delay circuit to ensure reliable operation. When the operation button is pressed, the compressor will start running within three minutes. In the event of power failure, the unit will stop. When the power is restored, the unit will restart automatically after three minutes.

Simply set the FAN SPEED selector button to the position.

A microcomputer in the air conditioner automatically controls the fan speed

when the mode is selected. When the air conditioner starts operating, the difference between the room temperature and the set temperature is detected by the microcomputer which then automatically switches the fan speed to the most suitable level.

When difference between
room temperature and set	FAN SPEED
temperature is
4 °F and over	High
Between 4 °F and 2 °F	Medium
Below 2 °F	Low

When difference between
room temperature and set	FAN SPEED
temperature is
2 °F and over	High
Below 2 °F	Medium

The above table assumes that the sensor on the remote control is being used. Actual operation may differ slightly from the operation described in the table.

If you want to adjust fan speed manually during operation, just set the FAN SPEED selector as desired. [ , , or ]

OI-202-17EG 17