Sanyo RL2000 manual Using Your Phone’s Battery, Battery Capacity, Installingthe Battery

Using Your Phone’s Battery

Battery Capacity

Your PCS Phone is equipped with a Lithium Ion (LiIon) battery.

It allows you to recharge your battery before it is fully drained. The battery provides approximately 4.5 hours of continuous digital talk time (2.5 hours in analog) or approximately 140 hours of continuous digital standby time (23 hours in analog).

When the battery reaches 5% of its capacity, the battery icon blinks. When there are approximately five minutes of talk time left, the phone sounds an audible alert and then powers down.

Note: Long backlight settings, searching for service, vibrate mode, PCS Ready Link mode, and browser use affect the battery’s talk and standby times.

Tip: Be sure to watch your phone’s battery level indicator and charge the battery before it runs out of power.

Installingthe Battery

Your PCS Phone comes with a LiIon battery. Follow these steps to install it:

1. Place the battery into the space beneath the antenna with the metal contacts at the bottom, facing downward.

2.Gently press down until it’s in place and the battery release latch snaps.

Removingthe Battery

To remove your battery, follow these easy steps:

1. Make sure the power is off so that you don’t lose any stored numbers or messages.

2. Push the battery release latch up and hold the battery.

3.Pull the battery up and out at a 45-degree angle.

Section 2: Understanding Your PCS Phone

2A:Your PCS Phone – The Basics 13