Sanyo SAP-CMRV1426EH-F English, Connecting a Home Automation Device, Installation Check Sheet

7. Connecting a Home Automation Device

The HA (white) 4P terminal is located on the indoor unit PCB. If a HA device will be used, connect it to this terminal.

Also, refer to Section 9. Electric Wiring Diagram in the outdoor unit installation manual.

8. Installation Check Sheet

The strength of the installation location is sufficient to support the Air Conditioner weight. The indoor and outdoor units are installed level and vertically.

The power and voltage are as specified.

Inter-unit cables are securely fastened to the terminal board.

Inter-unit cables are securely fixed.

The power cord and inter-unit cables are not connected anywhere along their paths. The ground wire is securely connected.

An air purge of the refrigerant circuit has been conducted.

A leak test of the tubing connections has been performed.

Thermal insulation has been applied to the tubing connections.

Drain connections are secure and water drains properly.

Putty has been used to close the hole in the wall.

All service valves are fully open.

Remote controller signals are being positively received.

9. Electric Wiring Diagram

Indoor Unit

SAP-KMRV74/94/124EH

English

EVAPORATOR
	YEL/GRN
	CONNECTOR
		1	1	RED
		2	2	PNK
FLAP		3	3	BLU
		4	4	BRN
		5	5	YEL

FLAP MOTOR
	RED
	BLK
FM
	WHT
	YEL
	BLU
FAN MOTOR

										TERMINAL BASE
									BLK					1
									WHT						2
									RED						3
													4
		AC1 AC2 SI							1	1		RED				1		1		IND
									2	2		WHT				2		2
1	1								3	3		WHT				3		3
2	2	5P(WHT)				LAMP														LAMP
									5	5		WHT				5		5
4	4
3	3	FLAP							4	4		WHT				4		4
				10P(WHT)
									6	6		WHT				6		6
5	5																			ASSY
									8	8		WHT				8		8
									7	7		WHT				7		7
									9	9		WHT				9		9
		CONTROLLER							10	10		WHT				10		10
											ROOM THERMISTOR
1	1								1	1		BLK
			ROOM/COIL						2	2		BLK
2	2
		DCM		4P(WHT)					3	3		BLK
3	3
									4	4		BLK
4	4	6P(BLU)
											COIL THERMISTOR
5	5
6	6
							ION		1	1		WHT				1	1
									2	2		RED				2	2
				3P(WHT)					3	3		BLK				3	3
											CONNECTOR
						HA
					JEM-A
																		BLK	BLK		RED	WHT
					4P(WHT)						BLK
					1	2	3	4
																		1	2		3	4
						ION												1	2		3	4
																ION ASSY
						TERMINAL

TO OUTDOOR UNIT

Fig. 33a 8FA-2-5257-72600-1

19