Sanyo SAP-CMRV1426EH-F, SAP-CMRV1926EH Install in a location where at least two sides are unob

2-3. Outdoor Unit

AVOID:

●heat sources, exhaust fans, etc. (Fig. 5a)

●damp, humid or uneven locations.

DO:

NO Exhaust fan

Hot air

Heat source

Outdoor unit

English

● position the outdoor unit in a protected location

where snow will not blow into it.

● choose a place as cool as possible.

● choose a place that is well ventilated.

● install in a location where at least two sides are unob-

structed, so that the flow of air at the intake port or

exhaust port is not blocked, and so that sufficient

space is ensured for maintenance to be carried out

without trouble.

In general the top also must be unobstructed.

(Fig. 5b)

● provide a solid base (level concrete pad, concrete

block, 15 ⋅ 40 cm beams or equal), a minimum of

15 cm above ground level to reduce humidity and

protect the unit against possible water damage and

decreased service life. (Fig. 5c)

● install cushion rubber under unit’s feet to reduce

Fig. 5a

Air intake		Min. 20 cm		Valve
				side
				Min.
				25 cm
Min.	Air discharge		Min.
10 cm
			50 cm

Fig. 5b

Obstacle above		Obstacle
dischargeAir
	Min.	Min.
	2 m	2 m
Ground	Min. 20 cm
	Air intake

vibration and noise. (Fig. 5d)

● use lug bolts or equal to bolt down unit, reducing

vibration and noise.

Anchor bolts (4 pcs.)

● install in a location where no antenna of a television

or radio exists within 3 meters.

Air intake

Concrete or equal

Min. 15 cm

About		15	cm
	40	About
		cm

Fig. 5c

Cushion rubber

Fig. 5d

10