AdonisC2_ENcopy122F_FM.book Page 55 Thursday, February 15, 2001 3:23 PM
Sort/Stack/Staple
To Stop Scanning Temporarily
When you are using the Sort, Stack, or Staple function, the originals are scanned into memory.
A Press the {Clear/Stop} key to stop originals from being scanned into memory.
To resume scanning
A Press the [No] key to resume scanning.
Note
❒Scanned images in memory are not cleared.
To clear scanned images of the originals
APress the [Yes] key.
Scanning is stopped with the images cleared.
When Memory Reaches 0%
Scanning will be stopped if the size of scanned image data exceeds memory capacity.
Note
❒There is enough memory to store
approximate 1,000 originals of A4, 81/2" ⋅ 11" size. The number of originals that can be stored in memory varies depending on the memory setting and original type. In addition, the number of origi- nals that can be stored in memory will be reduced when you use oth- er functions.
Reference
Scanning will stop when memory reaches 0% during sorted copying. However, you can change this set- ting so that all the scanned pages are copied and delivered to the tray first, then the machine auto- matically continues scanning the 2 remaining originals. ⇒ “Memory
Full Auto Scan Restart” in P.233 “Input/Output”.
A Press the {Start} key.
The scanned pages are delivered to the tray. Then, the image data in memory is cleared.
B Remove the copies and continue copying by following the instruc- tions on the display.
To Remove the Paper from the Staple Unit
If you cancel the stapling copy job in the middle of the job, the paper might be left in the staple unit. In this case, remove the paper from the staple unit.
A Press the {Clear Modes} key to can- cel the copy settings.
B Set the next original, then press the {Start} key.
The paper left in the staple unit is automatically delivered, then the next job starts.
Note
❒When the paper is not delivered and the message is displayed, follow the instructions on the display to remove the paper.
55
