AdonisC2_ENcopy122F_FM.book Page 63 Thursday, February 15, 2001 3:23 PM
Copying from the Bypass Tray
When Copying onto OHP Transparencies or Thick Paper
To make copies onto OHP transpar- encies or thick paper, you need to specify the paper type.
Note
❒Select [Thick Paper] if the paper weight is more than 128g/m2, 34 lb.
A Open the bypass tray, and adjust the guides to the paper size.
Important
❒If the guides are not flush with the copy paper, a skew image or paper misfeeds might occur.
B Lightly insert the OHP transpar- encies or thick paper face down until the beeper sounds.
The k indicator on the display au- tomatically goes on.
Important
❒When you set an OHP transpar- ency, make sure that its front and back faces are properly po- sitioned.
❒To avoid paper misfeeds, fan the paper before setting it in the tray.
C Press the {#} key.
D Select [OHP Sheet] or [Thick Paper].
E Press the [OK] key.
F Set your originals and press the {Start} key.
Important
❒When copying onto OHP trans- parencies, remove copied sheets one by one.
G When your copy job is finished, press the {Clear Modes} key to clear the settings.
2
63
