Seiko Group IP-6600 manual Turn on Heater

Turning the Power On/Off

When the switch is turned ON, a power-on self-diagnostic test is performed and the following message appears on the LCD on the operation panel.

Booting

INITIALIZING

WAIT A MOMENT

PRINT READY

ROLL : 64” (PAPER)

If a 64" paper roll is used

The heater control panel is displayed by turning the printer power ON. However, turn the heater power ON to use the heater.

When the heater power is turned OFF, the following message is displayed on the heater control panel.

TURN ON

THE HEATER

Section 2 Basic Operations

NOTE

- Turn OFF the printer while “PRINT READY” is displayed on the LCD panel except emergency.

Do not turn OFF the printer while “INITIALIZING” or “CLEANING” is displayed on the LCD panel to avoid drop of the ink and damage of the head.

- If the fan does not run or the operation panel lamp does not

HINT

light when the printer switch and power ON/OFF switch on the operational panel are turned ON, the power supply may be faulty.

-If an error is detected during the self-diagnostic test at powering on, an error message appears on the LCD. See the Section 5, Troubleshooting and take an appropriate measure.

2-7