Seiko Group IP-6600 manual Select *Yes or No of back feed operation, Select a paper type again

6	Select “*Yes” or “No” of back feed operation.
	PAPER FEED BACK	PAPER FEED BACK
	*NO	*YES

The area from the paper output sensor position to the print start position (the grid roller) becomes print dead area.

The print dead area can be decreased by rewinding the paper for length between the paper output sensor and grid roller.

(20 to 30 mm from the front edge cannot be printed.)

NOTE

-Cut the edge of the paper so that it will be parallel to the guide line before installing the paper.

If the edge of the paper is not parallel to the guide line, the front side of the print is cut, the platen is stained with ink, and the paper jam may be caused.

7 Select a paper type again.

SELECT PAPER TYPE

PAPER: TYPE01

PREPARING PAPER

WAIT A MOMENT

NOTE

-When using the origin point setting function, keep front, right, and left margins sufficiently because the paper is rewinded manually.

-The paper width and base point settings cannot be saved.

-The origin point setting function can be used only for paper roll. This function cannot be used for the cut sheet.

2-34