Seiko Group IP-6600 manual Heater preset temperature by medium, Front Print Rear

Changing Heater Control Setting Temperature

Heater preset temperature by medium

The heater preset temperature for medium is listed in the table. Preset the heater temperature according to the media you use.

		Recommended preset
Medium	Media Type		temperature			Print mode
		FRONT		PRINT	REAR
Glossy vinyle	Glossy	45° C		40° C	45° C	4 path
chrolide						bi-direction
Mat vinyle chrolide	Matte	45° C		40° C	45° C	4 path
						bi-direction
Banner	Banner	45° C		40° C	45° C	4 path
						bi-direction

Section 2 Basic Operations

NOTE

-When the rear heater temperature is set to high, fixibility of the ink is improved, but media wrinkle or mat print may be caused.

Adjust heater temperature according to the media type and environmental temperature.

-Set the front/rear heater temperature higher 5 °C than the print heater’s.

Bad temperature balance between the front/rear heater and print heater may cause media wrinkle.

2-41