Note: Do not use the same swab for each wiper

Inspection & Maintenance

Check no dregs of the dried ink and no damage on the blades.

Clean the front and back of the blades with the swab infiltrated into the wiper cleaning liquid.

After completion of the cleaning, close the wipe cover and the rear cover to return the wiper to the position as it was.

Wiper blades

Section 2 Basic Operations

<Test Print>

Enter to the “ADJUST” menu and select “TEST PRINT” on the operation panel. (See page 3-19.)

Check no print dot-off and missing.

Perform the test print as the 1st time print on every day and especially after cap cleaning for head cleaning.

When the print dot-off occurs at test print, enter to the “CLEANING” menu and select “NORMAL.” (See page 3-25.)

NOTE

-Do not leave the head carriage at the position other than on the capping unit for a long time (more than 5 minutes).

-Perform the normal head cleaning after completion of the test print.

2-51

Page 95
Image 95
Seiko Group IP-6600 manual Test Print, Inspection & Maintenance