3. COPYING IN THE AUTOMATIC PAPER SELECTION MODE

When the power switch is turned ON, the Automatic Paper Selection (APS) mode is set as the default mode.

In this mode, if you place an original on the original feed tray or on the glass, the copier automatically detects the size of the original, and selects paper of the same size as the original. This mode is available only for actual-size (100%) copying.

1

Check that the Automatic Paper Selection

mode is selected.

2 Place the original(s) on the original feed tray or on the glass.

When Using the Automatic Document Feeder

. After aligning the edges of the originals, set them face up on the original feed tray and align the slides to the edges of the originals.

. The number of originals you can load at a time is shown below.

Letter, Letter-R, Statement-R : 60 Ledger : 30 Legal : 35

. When the START key is pressed, the sensor detects the size of the original, and selects the paper size matched to the original.

Note: Remove any paper clips or staples from originals before placing them on the original feed tray.

Slides

24

Page 28
Image 28
Sharp AR-650 Mode is selected, Check that the Automatic Paper Selection, When Using the Automatic Document Feeder