3 Place the original(s) on the original feed tray or on the glass.

When Using the Automatic Document Feeder

. After aligning the edges of the originals, set them face up on the original feed tray and align the slides to the edges of the originals.

Note: Remove any paper clips or staples from the originals before placing them on the original feed tray.

USINGTHE

EDITING FUNCTIONS

Slides

 

When Placing the Original on the Glass

. After lifting the automatic document feeder, place the original on the glass face down with the bottom toward you and the left side centered against the original scale.

. Close the automatic document feeder slowly after the original size has been detected.

4

5

Select the desired copy size, exposure, reproduction ratio and copy quantity.

Press the START key.

Tip: Edges can be erased also in the bypass copy mode. To do this, set the paper in the sheet bypass (see page 50), and press the desired COPY-SIZE key to select the paper size. If LETTER-R paper is used, press the corresponding COPY-SIZE key twice.

59

Page 63
Image 63
Sharp AR-650 operation manual Usingthe Editing Functions